Feel free to use our complete database with charts, tables and examples.
Infliximab (Remicade ® )
|The authors make no claims of the accuracy of the information contained herein; and these suggested doses and/or guidelines are not a substitute for clinical judgment. Neither NewMedicalTerms Inc. nor any other party involved in the preparation of this document shall be liable for any special, consequential, or exemplary damages resulting in whole or part from any user's use of or reliance upon this material. PLEASE READ THE DISCLAIMER CAREFULLY BEFORE ACCESSING OR USING THIS SITE. BY ACCESSING OR USING THIS SITE, YOU AGREE TO BE BOUND BY THE TERMS AND CONDITIONS SET FORTH IN THE DISCLAIMER.|
Standard Dilutions [Amount of drug] [Infusion volume] [Infusion rate]
| [Prescribed dose] [250 ml] [2 hours]
Recommended conc: 0.4 to 4 mg/ml
Infusions less than 2 hours are not recommended.
Stability / Miscellaneous
| Stability: Use immediately.
Infusion should begin within 3 hours of preparation.
Label: Do not shake.
Reconstitute each vial with 10 ml of sterile water for injection using a syringe with a 21-gauge needle or smaller. Direct stream to sides of vial. Do not use if vacuum not present in vial. Gently swirl solution by rotating vial to dilute; do not shake. May foam upon reconstitution; allow to stand for 5 minutes. Solution is colorless to light yellow and opalescent; a few translucent particles may develop as infliximab is a protein. Do not use if opaque particles, discoloration, or other particles occur. Withdraw volume of total infliximab dose from infusion container containing 250 ml 0.9% NaCl. Slowly add total dose of infliximab for a concentration ranging from 0.4 to 4 mg/ml. Mix gently. Do not reuse or store any portion of infusion. Use an in-line, sterile, non-pyrogenic, low protein-binding filter with 1.2 micron pore size or less.
DOSAGE AND ADMINISTRATION
Crohn's Disease or Fistulizing Crohn's Disease
The recommended dose of REMICADE for children with moderately to severely active Crohn's disease is 5 mg/kg given as an induction regimen at 0, 2 and 6 weeks followed by a maintenance regimen of 5 mg/kg every 8 weeks.
Administration Instructions Regarding Infusion Reactions
During infusion, mild to moderate infusion reactions may improve following slowing or suspension of the infusion, and upon resolution of the reaction, reinitiation at a lower infusion rate and/or therapeutic administration of antihistamines, acetaminophen, and/or corticosteroids. For patients that do not tolerate the infusion following these interventions, REMICADE should be discontinued.
During or following infusion, patients that have severe infusion-related hypersensitivity reactions should be discontinued from further REMICADE treatment. The management of severe infusion reactions should be dictated by the signs and symptoms of the reaction. Appropriate personnel and medication should be available to treat anaphylaxis if it occurs.
Preparation and Administration Instructions
REMICADE vials do not contain antibacterial preservatives. Therefore, the vials after reconstitution should be used immediately, not re-entered or stored. The diluent to be used for reconstitution is 10 mL of Sterile Water for Injection, USP. The total dose of the reconstituted product must be further diluted to 250 mL with 0.9% Sodium Chloride Injection, USP. The infusion concentration should range between 0.4 mg/mL and 4 mg/mL. The REMICADE infusion should begin within 3 hours of preparation.
1. Calculate the dose and the number of REMICADE vials needed. Each REMICADE vial contains 100 mg of infliximab. Calculate the total volume of reconstituted REMICADE solution required.
2. Reconstitute each REMICADE vial with 10 mL of Sterile Water for Injection, USP, using a syringe equipped with a 21-gauge or smaller needle. Remove the flip-top from the vial and wipe the top with an alcohol swab. Insert the syringe needle into the vial through the center of the rubber stopper and direct the stream of Sterile Water for Injection, USP, to the glass wall of the vial. Gently swirl the solution by rotating the vial to dissolve the lyophilized powder. Avoid prolonged or vigorous agitation. DO NOT SHAKE. Foaming of the solution on reconstitution is not unusual. Allow the reconstituted solution to stand for 5 minutes. The solution should be colorless to light yellow and opalescent, and the solution may develop a few translucent particles as infliximab is a protein. Do not use if opaque particles, discoloration, or other foreign particles are present.
3. Dilute the total volume of the reconstituted REMICADE solution dose to 250 mL with 0.9% Sodium Chloride Injection, USP, by withdrawing a volume of 0.9% Sodium Chloride Injection, USP, equal to the volume of reconstituted REMICADE from the 0.9% Sodium Chloride Injection, USP, 250 mL bottle or bag. Slowly add the total volume of reconstituted REMICADE solution to the 250 mL infusion bottle or bag. Gently mix.
4. The infusion solution must be administered over a period of not less than 2 hours and must use an infusion set with an in-line, sterile, non-pyrogenic, low-protein-binding filter (pore size of 1.2 µm or less). Any unused portion of the infusion solution should not be stored for reuse.
5. No physical biochemical compatibility studies have been conducted to evaluate the co-administration of REMICADE with other agents. REMICADE should not be infused concomitantly in the same intravenous line with other agents.
6. Parenteral drug products should be inspected visually for particulate matter and discoloration prior to administration, whenever solution and container permit. If visibly opaque particles, discoloration or other foreign particulates are observed, the solution should not be used.
NDC 57894-030-01 100 mg infliximab in a 20 mL vial
©Centocor, Inc. 2006
Source: [package insert]